LM75BD,112【PDF 11/37 页】IC TEMP SENSOR DIGITAL 8-SOIC

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录41

7页 8页 9页 10页 [11页]12页 13页 14页 15页

LM75B

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 5 22 January 2014

11 of 37

NXP Semiconductors

LM75B

Digital temperature sensor and thermal watchdog

7.5 OS output and polarity

The OS output is an open-drain output and its state represents results of the device

watchdog operation as described in Section 7.1

. In order to observe this output state, an

external pull-up resistor is needed. The resistor should be as large as possible, up to

200 kW, to minimize the Temp reading error due to internal heating by the high OS sinking

current.

The OS output active state can be selected as HIGH or LOW by programming bit B2

(OS_POL) of register Conf: setting bit OS_POL to logic 1 selects OS active HIGH and

setting bit B2 to logic 0 sets OS active LOW. At power-up, bit OS_POL is equal to logic 0

and the OS active state is LOW.

7.6 OS comparator and interrupt modes

As described in Section 7.1

, the device OS output responds to the result of the

comparison between register Temp data and the programmed limits, in registers Tos and

Thyst, in different ways depending on the selected OS mode: OS comparator or

OS interrupt. The OS mode is selected by programming bit B1 (OS_COMP_INT) of

setting to logic 0 selects the OS comparator mode. At power-up, bit OS_COMP_INT is

equal to logic 0 and the OS comparator is selected.

The main difference between the two modes is that in OS comparator mode, the OS

output becomes active when Temp has exceeded T

th(ots)

and reset when Temp has

dropped below T

hys

, reading a register or putting the device into shutdown mode does not

change the state of the OS output; while in OS interrupt mode, once it has been activated

either by exceeding T

th(ots)

or dropping below T

hys

, the OS output will remain active

indefinitely until reading a register, then the OS output is reset.

Temperature limits T

th(ots)

and T

hys

must be selected so that T

th(ots)

> T

hys

. Otherwise, the

OS output state will be undefined.

Table 13. Tos and Thyst limit data and value

11-bit binary

(twos complement)

Hexadecimal value

Decimal value

Value

0 1111 1010

0FA

250

+125.0 癈

0 0011 0010

032

+25.0 癈

0 0000 0001

001

+0.5 癈

0 0000 0000

000

0.0 癈

1 1111 1111

1FF

-1

-0.5 癈

1 1100 1110

1CE

-50

-25.0 癈

1 1001 0010

192

-110

-55.0 癈

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式